Recent content by rhorn

I got it fixed it ended up being the ignition switch: :thumbsup::thumbsup: thanks for all your help. new problem is it takes awhile to start now, it used to start on the first few cranks of the engine. I'm going to pull the plugs tomorrow I'll let you know if I find anything Thanks again

Ok the numbers in parentheses are voltage readings. for the ground I set the voltmeter on the positive side of the battery.. I believe that is too see if there is a voltage drop. car is not running, first test is for battery voltage at ecm pin in fuse box, next I tested for ground at #86 pin...

i have no fuel pressure... I was on youtube and found a video from May03lt he says hes part of this site, anyway I followed his instructions for checking the fuel pump relay circuit. I tried swaping out another relay with the fuel relay. I have battery voltage at the ecm pin (12.48) I have a...

Ok, this is what’s going on, as suggested I took the car and had a case relearn done, the GM mechanic said that the light could be coming on because of too much end play in the crank shaft or a timing chain issue. I’m personally not buying either, l say this because when I drive to work in the...

I replaced cam shaft, crank shaft, sensors, new camshaft solenoid, drove car around on Sat, light went out, got back in car this morning to go to work lights back on, Help !!!!!

I didn't get case relearn done yet... (didn't know I needed too) just replaced CPAS with one purchased from dealer.. light was out (dealer 5 miles from home). I started it up light was out went in washed up restarted car, lights back on.. went to Advance auto they scanned for codes I still...

I recently replaced cam shaft and crank shaft sensors I've also cleaned Camshaft Position Actuator Solenoid, Now a little backround SES light was on I pulled a p0016 code I replaced cam sensor light stayed off for about a week, light came back on pulled same code. replaced crank sensor again...