Recent content by gmac310

Heat it with a torch, not only will the metal expand but it will help the penetrant soak in better.

That's not a push connect, it's a clamp to hold the line to the frame. It's the return line that's on the side closest to the fender. If you trace it down it should go to the cooler. Almost everyone has had to replace them and it's a PITA so I would replace both anyway while you're at it unless...

That's for jump starting! lol

The only error was it was Fort McHenry NOT Fort Henry

Sad to see another Envoy off the road but at least it went out in a blaze of glory! http://www.nbcnews.com/video/st-louis-fire-dept-respond-to-suv-crashed-through-home-1001561667956

I had this on one of my hubs and when I removed the sensor the reluctor was filled with grease. No way of getting that out from between the teeth so I had to buy another one.

Welcome to the club. I had both of mine rot out to the point of being turned down for a sticker. I went and got a piece of 3/16" mild steel and cut and bent the pieces myself large enough to actually enclose the whole original and weld the seams.

The hardet part is trying to unhook the fuel lines while the tank is hanging partway down because you can't get your hand in there while the tank is still bolted up and the lines aren't long enough to allow the tank to drop all the way to the ground.

I would say so, I don't think any of the GMTs use different bumpers between their SWB and LWB versions.

Parking brake will still work without backing plates. The cable attaches to the center "hub" of the axle not the backing plate.

Who is that in the video, Darth Vader? Mouth breathe much?!

Mine did this the other day but mine was p0306 for a bad #6 coil pack. Replaced with another one I had kept off my old engine but skip persisted with a p0300 code this time and eventually turned into a p0306 code again. Drove it for a day while I had to wait for a snowstorm to pass before trying...

Not needed, just toss it

Pfft, what a ripoff! Shipping should be free!!

Typical Craigslist ad, little to no picture value!