Recent content by Scrappy608

Thanks, I appreciate that 🍻

I did this for my Chrome Hood Trim piece and thought i would share the how to. If you try this be safe and ise common sense :smile: Removing Chome off ABS Plastic to paint: You got chrome plastic you want to repaint? here you go!! Recipe to strip chrome plating off of ABS plastic...

After getting into an accident and having the bumper cover shatter due to extreme cold wisco winter days, i decided no time like the present to do some upgrades to the looks. So i did this with the bumper cover off (so i could work in a warm house not cold garage and also have every angle...

Hey JD, what did they get you for that there? Curious as I may find myself going that route.

Ok! Final update: Up and running 🤘🏼 I jumped the main orange at the body side 5 wire connector to the gate side orange that home runs to the wiper motor and voila! rear wiper is workin like it should now! This jump was done in the gate itself where there is more real estate to work with...

That is very helpful. Thank you. So, the connector to the body and the gate is the only place where the 3 orange wires are seen. One of those orange wires goes directly to the wiper motor and the other two go to the LGM. I appreciate it

I think you are 100% right...I will need to get creative :) I pulled the old harness outta the '02...but then thought..."nah, they gotta be the same"....and now it is in some recycling centers pile. I appreciate you weighing in on this old topic Moosman.

Are you referring to the LGM? If so, when I replaced the tailgate I did move over my original LGM into the replacement (because otherwise as mentioned earlier, the key fobs dont work without re-programming) The '02 has a 5 wire (2 orange), and the newer one has a 6 wire connection (3...

UPDATE: So my truck is an '02 and the liftgate is from an '06 or '07. The photo I sent last night of the harness connector was from the body side and only has the two orange....however the gate side of the connector has 3 orange..... and sure enough, at the wiper motor I am not getting 12v. I...

I do have 12v on both orange wires and continuity to body at ground at this connector. i haven't chased back into the wiper motor yet. i replaced my tailgate with one from a junk yard (needed better back glass) and swapped over the LGM from my original (pro tip: the key fob is programmed to...

Well this group and knowledge in this thread is extremely helpful! I have the everything works bit the wiper issue and went i to the boot and found one orange and my black pinched and exposed. i cut out the bad and replaced with good. unfortunately issue remains. mine seems odd because i...