Recent content by rmsg0040

SOLD!

Finally got pics! Been so busy

Pics soon.... Brand new spal fan va18-ap71/ll-59a, made in Italy Was going to install, truck sold since Minor damage to one of the tabs, but doesn't affect operation Same fan pcmofnc uses for the I6 fan kits: http://www.pcmofnc.com/product/i6-trailblazer-plug-and-play-fan-kit-3/ fab up a...

SOLD!!!

^^ yes that is the correct link Thanks

Bump

In terms of shipping, we can figure something out. Thanks

SOLD!!! Brand new, bought with the intention of installing, never got around to it, Trailblazer has been sold since Located in Brampton, ON Asking $145 CAD or $110 USD, basically half of what PCM of NC sells it for...

Another tip is to pull the slide pins out, clean and grease with appropriate lube. I had a stuck pin on my driver's side rear that wore the pads down to bare metal and ruined the rotors, the other side was fine.

Lift was bought in used condition, guy delivered it to my door for $700 Its electric/hydraulic, make/model is wheeltronics 6500 Snap On tools bought out wheeltronics during the 2000's and started to label them as their own. Wheeltronics 6500 = Snap On EELR338A...

Lifted it, sorta. Actaully testing out the scissor lift and trying to find the suitable lift points. Will be fully utilized when I get a high lift garage kit.

Harbor Freight toolboxes 44, 56, and 72 seem to get good reviews

If you can get 100K out of the "new transmission", what's $2000. That's the way I look at it. Plus you got a vehicle that you know and you don't have to worry about new car payments. Short term pain, long term gain.

Earlier this year my power steering cooler started to leak, replaced it myself. The very next day one of the transmissions lines started to leak. I looked at the job and decided that it was going to be a pain. Took it to a shop, they purchased the bent lines from GM, took a few hours on their...

^^ I would say buy the adapter set and your good. I did the lower ball joints with the kit and it works good, only thing I had to do to make it work was to remove the rubber boot. Kind of a pain to put the boots back on. I used moog lower ball joints...