Recent content by nbenjamin

Sorry I think I miss understood what you were saying I should be ok with the clips. I thought u meant change plastic lines ends with the clips

https://www.rockauto.com/en/parts/tyc,150095,fuel+pump+&+housing+assembly,10147 Opinions? I read that some had issues with Bosch About the pump lines rusted when you guys say the ends you mean the ends that the connector is attached to ? Are they not crimped on ?

Problem with ground wires ??

I think if my notes are correct is was OEM sending unit. I agree about keeping the pump and having it as a spare except it will depend on how bad the leak is from the pump lines how badly rusted and rotted out. Also just replacing the old sending unit won’t do me much good because if the lines...

Thanks for all the replies guys I think I have 2 issues The tank must be leaking from the pump. Judging by the pics I have from 2011 when I changed the sending unit the fittings on the pump were rusted then and it’s been since 2011 and 100,100km since I did the sending unit. The tank had...

I believe the stepper motor is fine. When I start it goes to 1/4 maybe then after a while empty then maybe 1/2 then after driving for a bit back to 0. I just find it hard to believe everything is failing again since battery change. Then again nothing really surprises me with these gm vehicles...

So still got the not ready for emissions cause of mass leak. I now know the leak is from the pump. There is gas leaking down the tank when engine running. Will replace pump as soon as this cold weather is gone. I noticed since battery change gas gauge all over the place Would tank not...

Screens were still there just opened , I notice the online ones had retention wires the one I got here locally didn't have any I think the Dorman make I got

Let me see if I can make sense Truck acting up again. had A P0014 and the usual stalling rough static idle , cam shaft solenoid missing screens etc. Changed it along with over due oil change. I notice it was getting harder to start just before I changed solenoid. Changed it nice clean oil idle...

I will do that this week , will check tomorrow to see if maybe I have loose intake bolts I assume that could cause the hiss ???

I have a innova 3100 I think it will or caaputre freeze frames any help u can give would be great thanks . I have done the old school pour or spray around intake for sound Also just comfirmed I think its a bad coil too . Code changed from p305 to p302 I switched coil ffom cylinder 5 to 2...

May sound stupid but vacuum ? And u mean for a code with scan gauge ? Or my obd2 reader. Thanks

I drove the truck today see if I can figure out the hissing sound Here is what I found and has me stomped When idle in park I can floor the pedal no sound When driving if I floor the pedal I can hear it under the drivers side to the back makebe Sounds Like a air hose then stops as soon as...

wife just called , she she said she hears a hissing sound like a lose when she accelerates ..... I am assuming its intake manifold blots lose ??? i told her its OK to drive it home . curious what does the fan sound like when clutch is going ? roaring sound or hissing sound ?

Mevotech